Queen bed frame metal – Starting with fitting headboard brackets to shoulder rivets at the end of the side rails. Ensure headboard brackets by passing a bolt through each of the two holes between the bracket and rivets. Screw a washer and nut on each bolt. Tighten the nut and bolt. Headboard brackets can be installed facing depending on the size of the headboard. Then, push one end cap into the end of each side rail. The output cap will protect metal against tear your sheets or cut you if you graze against it hard enough. Swing out two cross-arms on each side rail to make a 90-degree angle.
Next steps to assemble a queen bed frame metal is put two side rails on the ground parallel to each other. Connect the side rails by inserting the two pins on each cross arm of the two holes at the end of the cross arms at the opposite side rail. When the pins are in the holes, pulling the side rails in opposite directions to lock the pegs in the holes. Next, lay cross-support between the sides rails in the center; Look for a hole on each side rail where the cross supports will attach.
12 Photos Gallery of: To Assemble a Queen Bed Frame Metal
Align the holes across support and side rails. A bolt inserted in each hole. Put a washer and nut on each bolt. Tighten bolts with a wrench to secure the transverse support in place. Last, insert gliders or wheels that came with your bed. Inserting points down queen bed frame metal legs into the hole of each slider and gravity will ensure slider on the leg. Insert the plastic socket in each frame leg wheels, and then insert a wheel in each plastic socket.